XXX DRIVEWAY SUPREMACY

Shampoo:

Park in the shade if possible, and ensure the surface is cool to touch. Hose off any loose dirt from the surface.

If you have a foam gun & pressure washer:

Mix 900mls of water with 100mls of shampoo in your foam gun chamber. Foam the surface & let it dwell for 3-5 minutes. Rinse off & repeat if necessary
.

2-bucket manual wash:

Fill 2 10L buckets with water. Add about 50mls of Shampoo to one of the buckets and shoot a sharp stream of water in there to agitate the mixture & create suds. Begin washing.
Rinse your wash mitt in the water-only bucket every 30 seconds to remove any dirt from the mitt. Dunk it back in the soapy bucket & continue washing. Repeat until surface is clean. Rinse off.

Wash Mitt:

Dunk it in & out of your soapy wash bucket solution until the entire mitt is saturated & covered in bubbles. Apply with very minimal pressure and allow your cleaning shampoo to do the hard work. Glide the wash mitt over each section of the exterior, making sure to rinse off any dirt that may have attached – every 30 seconds or so.

Drying towel:

Wipe over your car in straight line passes. Take extreme care to ensure that no part of your drying towel touches the ground. Continue wiping over each section of your car until every panel is thoroughly dry.

Bloodbath:

Shake bottle well and apply it to a cool dry surface – out of direct sunlight. Mist the product directly onto the surface and allow it to sit for 1-2 minutes or until the treated area remains a reddish/purple colour. Rinse off thoroughly with a sharp stream of water or with a pressure washer for best results. Do not allow Bloodbath to dry onto the surface. Spray on a bit more to keep it wet if drying occurs, or hose it off & reapply.

Mootjuice:

Shake bottle well and ensure the surface is freshly washed, completely dry, and cool to touch. Mist the product directly onto the surface, or onto a clean microfibre cloth, then lightly distribute the product over the applicable area. Using another clean microfibre cloth, buff that section to a high shine. Repeat this process on the remaining sections until finished. Mootjuice is not suitable for matte-finish surfaces due to its high gloss characteristics. Applying it to such a surface may compromise its appearance.

Fuckenmint:

Shake the bottle well and ensure the surface is cool to touch. Don’t apply in direct sunlight.
Mist the product directly onto the surface and let it dwell for about a minute. Rinse off with a sharp stream of water. For stubborn grime, apply a second time and rinse again. Follow with your regular soapy car wash routine to ensure no residue is left behind.
IMPORTANT: Do not allow Fuckenmint to dry on the surface. Spray on a bit more to keep it wet if drying occurs, or hose it off & reapply.